We are now offering a very helpful service for our ramp building customers. Side Transition Kits are precision cut pieces of the ramps...basically all of the difficult angles, notches and curves are done for you. You can unpack these parts after they are shipped to you, make some straight cuts and have your ramp framed in a few hours. This is a huge time saver and worth every penny. Go HERE to learn more.

We sell the best countersinks used to install ramp surfacing. You may purchase them in packs of four or six or just one if that's all you need. Go HERE to learn more.

If you are serious about ordering in some ramp surfacing such as Skatelite Pro or Ramp Armor Deluxe, you may want a sample packet shipped to you while we get your freight quote. This packet allows you to feel the different surfaces and decide upon the right color. Some good information about cost and shipping locations is also included. Go HERE to learn more.

We are now providing the best screws available for constructing your ramp or re-sheeting an existing ramp. These are GRK screws - the best in the business. They are super strong, easy to install and will last throughout the seasons of climate change that your ramp will go through. Go HERE to learn more.

Check out a new PICTURE INDEX we've made to help you see our categories of template plans.

A traceable template plan for the 3' quarterpipe with hip and ledges is available. Go HERE to learn more.

The 6' tall halfpipe with center street ramps is available in the online store. Go HERE to learn more.

 

Here are some shots of the 2 foot six inch tall micropipe. You can put these ramps in the garage or basement or even your living room if you so choose. Find out more about the traceable plan for this ramp HERE.

We provided templates and plans for Vinny's Skatepark in Nebraska. He's got a six foot tall bowl in there (which we also provided the bent coping for) and a few nice technical ramps with some ledges, stairs, euro gap etc...

We now offer steel coping that is roll bent to specific curves for skate bowls. Their 90 degree arcs are marked with tangent points and a little excess pipe for protection. When delivered to your location, you can cut the pipes at their tangent points and weld together with some straight pieces to complete the bowls shape.

Notch out a bunch of small rectangles with a circular saw and chisel and you can places coping plates in there to lock the steel coping to the bowls frame using the provided hardware and a welder. Call Brendan for an estimate at 406-253-5365

The traceable template plans are still available for the 4 foot tall halfpipe (most popular) as well as the 6 foot tall and 10 foot tall shown here. Click on the yellow link below to check out more.

GO TO THE ONLINE STORE TO ORDER